E-Cig Instructions
·
To turn the e-cig on/off press the
button 5 times fairly fast.
·
650 Upgrade battery: to change between the high and the low
setting turn the battery off and hold the button down for ten seconds until it
flashes.(Blue light indicate the low setting, white light indicate the high
setting.)
·
Variable voltage: To change the
voltage (strength) – twist the dial at the bottom to your desired strength
between 3.2v -4.8v.
Filling process:
·
Remove the tank from the battery;
hold it with the mouth piece facing down and un-screw the bottom of the tank.
(for bottom wick tanks)
·
Fill liquids into the tank but not
down the center hole.
·
Be sure to not over fill or liquids
may spill into the center passage way.
·
If liquid spills into the center hole
of the tank simply blow into it with a tissue underneath the mouth piece to
clear the passage way of liquid.
Cleaning process:
·
Remove the bottom part of the tank,
and rinse the part of the tank that holds the liquids with warm water only. DO
NOT rinse the wick or heating element with water.
·
Let the tank air dry or wipe dry with
a tissue.
·
Be sure not to wipe away any O-rings
that are on the tank and heating element or you may experience leaking.
·
Wipe the inside of the battery every
night to clean out any juice residue before charging it, this will ensure the
longest possible life for your battery.
Tips:
·
Do not leave your e-cig or juice in
the car or anywhere that is very hot, the juice expands in heat and your tank
will leak.
·
If your tank is leaking, rinse the tank
and clear the passage way by blowing into the tank WITHOUT the bottom part
attached, let dry and refill the tank as noted above.
·
Never screw your tank too tightly
onto the battery.
·
If the tank is leaking liquid into
your mouth and cleaning it does not help, you may be drawing too hard on the
tank, remember you draw on e-cigs slower and longer than regular cigarettes.
·
Wicks last about 10-14 days on
average. You will notice a burnt taste when the wick is ready to be changed.
No comments:
Post a Comment